View Issue Details

IDProjectCategoryView StatusLast Update
0000461Industrial-Craft²machinespublic2013-10-07 08:22
Reporterinucune Assigned ToThunderdark  
PrioritynormalSeveritymajorReproducibilityalways
Status closedResolutionno change required 
Summary0000461: Mass fabricator does not use the first piece of scrap completely
DescriptionWhen putting scrap into a mass fabricator, it does not use the first piece completely.
Steps To ReproduceI used a BC gate control for this.

1.hook a batbox directly to a mass fabricator.
3.place a BC pipe adjacent to the mass fab.
4.place a gate on the pipe, and configure it to emit a redstone signal unless there is amplifier in the mass fabricator.
5.charge the bat box to capacity, record the charge (40k). remove any power sources.
6.place only 1 scrap in the mass fab.
7.record the power drain from the bat box (320 eu in my tests)
8.recharge the bat box to capacity, remove source of power
9.place a stack of 2 scrap in the mass fabricator.
10. record the power consumption. (5120 in my tests)
(optional) repeat with 3 scrap, and so on.
Additional Informationin theory, the consumption for 2 scrap should be roughly double the consumption of 1. 3 scrap also shows that 2 scrap are consumed at the normal eu rate, with the additional 320 eu drain. however, some amount of amplifier is registered on the first piece or the gate would not have triggered.
TagsNo tags attached.
Minecraft Version

Activities

Thunderdark

2013-10-07 08:22

viewer   ~0001718

clean up Manits Bug Tracker..close automatic all Bug report > 3 months if the error still exists in the current version > IC2 2.0.248 please report new Thx.

Issue History

Date Modified Username Field Change
2013-06-29 21:04 inucune New Issue
2013-10-07 08:22 Thunderdark Note Added: 0001718
2013-10-07 08:22 Thunderdark Status new => closed
2013-10-07 08:22 Thunderdark Assigned To => Thunderdark
2013-10-07 08:22 Thunderdark Resolution open => no change required